Aluminium Plate

Product Stocking and Processing Service Program

Aluminium Plate
Alloy 5083, 5383, 5005, 5052, 5454, 5186
Temper H32, H34, H116, H321
Thickness (mm) 4 to 25
Width (mm) 1200 to 2500
Length (mm) 2400 to 12000, Customer specific length
Finish Mill, Customer specific linish, Bright
Coating PE Coating (not standard)
Plasma profile To customer drawings

The information provided is for standard stock product and does not encapsulate all available combinations. Please contact the nearest Atlas Steels sales outlet if non standard product is required and we will enquire about its availability through our global supply network of mills and stockists.

For further technical information on these products refer to the relevant section of the Atlas Product Reference Manual. There is other technical and product information contained within the Technical Library of this website.

Atlas Steels locations and contacts can be found in main menu of this website

 

Aluminium Plate Temper Codes

Code Description
H111 Strain hardened less than the amount required for a controlled H11 temper
H112 No special control over amount of strain hardening. Some minimum strength limits set.
H321 Strain hardened less than amount required for a controlled H32 temper.
H116 Acceptable resistance to stress, cracking and exfoliation attack. Strain hardened less than amount required for a controlled H32 temper.
H321/H116 Plate can be supplied with a dual temper from select mills.
H32 Strain hardened by rolling and then stabilising heat treatmenet to ΒΌ hard.

 

Plate Finishes

Bright: Principally used by the transport trucking industry this material is sourced from selected mills. Atlas market and stock this quality of plate in alloy 5083, temper H32.

Mill: this refers to plate supplied ex mill with a commercial finish. This material is typically used in the marine industry, general engineering and transport industry where bright plate is not critical.

Linish: This is a customer negotiated linish that can be processed at the Atlas service centre.

 

Aluminium Bend Radius
Displays the recommended minimum inside bending radii for 90 degree cold forming of sheet and plate. It covers most common alloys of aluminium and their temper range from thickness 0.4 mm to 12.0 mm.

 

.

<< Previous Page